Cisco 7301 Technical Information PDF herunterladen (Seite 9)

Attach the Rack-Mount Brackets—Chassis Rear-Mounted

Figure 5 Attaching the Rack-Mount Brackets to the Rear of the Chassis

Depending on how the rack-mount brackets are attached to the chassis, it either protrudes from the rack or is recessed in the

rack.

Step 1 Locate the rack-mount brackets and screws and a Number 2 Phillips screwdriver.

Step 2 Align the rack-mount bracket (1) to the side of the router and insert and tighten the screws (2). Depending on which

set of holes on the rack-mount bracket that you use, the router will either be recessed in the rack or protrude from the

rack.

Note To use the cable-management bracket with the Cisco 7301 router rear-mounted, you must purchase a second

rack-mount kit, attach a rack-mount bracket to the left front of the chassis, and attach the cable-management bracket

to it. See below for cable-management bracket installation instructions.

Go to the “Four-Post Rack Installation” section on page 10 or the “Two-Post Rack Installation” section on page 11.

Attach the Cable-Management Bracket

Figure 6 Attaching the Cable-Management Bracket

Rack-mount bracket

4 screws, 8-18 x .37 in., for use with a 19-inch rack

4 screws, 8 x .375 in., for use in a 21–23-inch rack

Cable-management bracket

M4 x 20-mm screw

ALARM

RJ45 EN

LINK

TX RX

GBIC

GIGABIT ETHERNET 0/2

RJ45 EN

LINK

TX RX

GBIC

GIGABIT ETHERNET 0/0

RJ45 EN

LINK

TX RX

GBIC

GIGABIT ETHERNET 0/1

CISCO 7301

SLOT 1

CONSOLEAUX

COMPACT

FLASH

STATUS

100-240V, 2A, 50/60 Hz

24V

9A, 48 - 60V

ENABLED

RX CELLS

RX CARRIER

RX ALARM

ATM

80907

ENABLED

RX CELLS

RX CARRIER

RX ALARM

80278

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco 7301 Technical Information Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco 7301