Cisco 7301 Technical Information PDF herunterladen (Seite 7)

• The native fiber optical Gigabit Ethernet ports and the RJ-45 Gigabit Ethernet ports are reported as GigabitEthernet 0/0,

GigabitEthernet 0/1, and GigabitEthernet 0/2 in software. You must use the media-type command to select which media type

you want to use before you configure these ports. See page 24.

Figure 2 Identifying SFP GBIC Module Latches

Different manufacturers have different types of latching mechanisms for Gigabit Ethernet SFP GBIC modules. There is no

correlation of the type of latch to the model (such as SX or LH) or technology type (such as Gigabit Ethernet) of SFP GBIC

modules. See the label for the SFP technology type and model. The SFP GBIC modules use LC-type connectors.

Figure 3 Inserting a SFP GBIC Module into a SFP GBIC Port

Step 1 Turn the SFP GBIC module so the latch is on the bottom. The SFP GBIC module is keyed to be inserted correctly.

Step 2 Insert the SFP GBIC module into SFP port 0/0, 0/1, or 0/2. Repeat Step 2 if you are inserting a second or third SFP

GBIC module.

Step 3 Do not remove the SFP GBIC module plugs until you are ready to install the cables.

Sliding latch

Hinged latch

Hinged and sliding latch

SFP GBIC port

Latch beneath plug

80755

1 2 3

RJ45 EN

LINK

TX RX

GBIC

GIGABIT ETHERNET 0/2

ETHERNET 0/0

LINK

TX RX

GBIC

RJ45 EN

LINK

TX RX

GBIC

GIGABIT ETHERNET 0/1

SERIES

CONSOLEAUX

COMPAC

FLASH

80269

TX RX

GBIC

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Keine Kommentare

Cisco 7301 Technical Information Seite 7