Cisco 675E Betriebsanweisung PDF herunterladen (Seite 20)

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices

Configure Applications

5-20

Cisco 600 Series Installation and Operation Guide

78-11190-01

NAT

The NAT application converts IP addresses on a private network (designated as

“inside” or “LAN”) to global IP addresses that can forward packets to another

registered network (designated as “outside” or “WAN”). To enable NAT:

Step 1 Enable NAT:

set nat enabled

Step 2 To check whether this feature is enabled, enter:

show nat

Step 3 Write the changes to NVRAM:

write

Step 4 Reboot the Cisco 67x:

reboot

For more information on using NAT, see the set nat series of commands in Cisco

Broadband Operating System User Guide.

RADIUS Client

RADIUS authenticates users for access to a network. The RADIUS server uses an

authentication scheme, such as PAP, to authenticate incoming messages from

RADIUS clients. When a password is present, it is hidden using a method based

on the RSA Message Digest Algorithm MD5 [1].

The Cisco 67x has been successfully tested for compatibility with the following

RADIUS server providers:

• Livingston Enterprises RADIUS 2.01

• Merit RADIUS (Sun binary)

• RADIUS NT (Microsoft)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

Keine Kommentare

Cisco 675E Betriebsanweisung Seite 20