Cisco 675E Betriebsanweisung PDF herunterladen (Seite 13)

5-13

Cisco 600 Series Installation and Operation Guide

78-11190-01

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices

Configure the WAN Ports and ATM Virtual Connections

To set the maximum number of VCs, enter:

cbos# set interface wan0 maxvcs

where n is between 1 and 8.

Table 5-2 shows the valid ranges for the VPI and VCI addresses.

Note In CBOS version 2.3 or earlier, the VPI count is 1 to 4. In later

versions, the VPI count is 1 to 8.

Changing VPI Settings

Step 1 To make sure the wan0-0 connection remains closed during configuration, enter:

set interface wan0-0 disable

Step 2 To set the VPI number to 2, enter:

set interface wan0-0 vpi 2

Note If you try to enter the command set interface wan0-1 on a

connection that is already open, the system prompts you to

close that connection before you change the VPI setting.

Close the connection by entering set interface wan0-1

close.

Table 5-2 VPI/VCI Address Ranges

Maximum VCs VPI Range VCI Range

1 0-3 0-63

2 0-3 0-63

4 0-3 0-63

8 0-3 0-63

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Keine Kommentare

Cisco 675E Betriebsanweisung Seite 13