Cisco 3620 Installationsanleitung PDF herunterladen (Seite 22)

22 Cisco 3600 Series Memory Upgrade Conﬁguration Note

Replacing Connections to the Router

Figure 17 Replacing the Cisco 3640 Cover

Replacing Connections to the Router

Follow these steps to make ﬁnal connections to the router:

Warning Read the installation instructions before you connect the system to its power source.

Step 1 Replace all network connections.

Step 2 If you have an AC-powered router, plug the power cord into a 3-terminal, single-phase

power source that provides power within the acceptable range (100 to 240 VAC, 50 to

60 Hz).

If you have a DC-powered router, remove the tape from the circuit breaker switch handle

and reinstate power by moving the handle of the circuit breaker to the ON position.

Step 3 Turn ON the power switch. The power LED on the front panel of the router should go

ON.)

Step 4 Check the OK LED on the right side of the front panel to verify that it goes ON after a

few seconds delay when booting.

Step 5 If you have problems, and you replaced the ROM, see the next section, “Testing ROM

Installation.” Otherwise, see the “Cisco Connection Online” section on page 23.

Chassis bottom

Side tabs

Front panel

H7044

Cover

tabs

Chassis

tabs

Cover tabs

Chassis cover

ACTIVE

READY

123

PCMCIA

SYSTEM

CON

AUX

RPS

1 2 ... 17 18 19 20 21 22 23 24

Keine Kommentare

Cisco 3620 Installationsanleitung Seite 22