Cisco 12012 Technical Information PDF herunterladen (Seite 48)

Command Reference

Release 11.2 GS

Table 3 describes the ﬁelds shown in the output and lists the equipment that is supported by each

environmental parameter. If an “NA” is listed in the ﬁeld and the equipment is supported, it means

that the reading could not be obtained. Try the command again.

The following is sample output from the show environment all command for the Cisco 12008. Slots

0 through 7 are the line cards, slots 16 and 17 are the clock scheduler cards (the clock scheduler cards

control the fans), slots 18 through 20 are the switch fabric cards, and slots 24 and 26 are the power

supplies. The Cisco 12008 does not support slots 25, 27, 28, and 29. An “NA” in the table means

that no values was returned. In some cases it is because the equipment is not supported for that

environmental parameter (for example, the power supplies in slots 24 and 26 do not have a hot

sensor, so an NA is displayed).

Router# show environment all

Slot # Hot Sensor Inlet Sensor

(deg C) (deg C)

2 31.0 22.0

5 33.5 26.5

16 25.5 21.5

18 22.0 21.0

19 22.5 21.0

24 NA 29.5

26 NA 24.5

Slot # 3V 5V MBUS 5V

(mv) (mv) (mv)

2 3292 5008 5136

5 3292 5000 5128

16 3272 NA 5128

18 3300 NA 5128

19 3316 NA 5128

Table 3 Show Environment Field Descriptions

Field Description

Slot # Slot number of the equipment. On the Cisco 12012, slots 0 through 11 are the line

cards, slots 16 and 17 are the clock and scheduler cards, slots 18 through 20 are

the switch fabric cards, slots 24 through 27 are the power supplies, and slots 28

and 29 are the blowers.

3V (mv) Measures the 3-volt power supply on the card. The 3-volt power supply is on the

line cards, GRP card, clock and scheduler cards, and switch fabric cards.

5V (mv) Measures the 5-volt power supply on the card. The 5-volt power supply is on the

line cards, GRP card, and power supplies.

MBUS 5V (mv) Measures the 5-volt MBus on the card. The 5-volt MBus is on all equipment.

Hot Sensor (deg C) Measures the temperature at the hot sensor on the card. The hot sensor is on the

line cards, GRP card, clock and scheduler cards, switch fabric cards, and blowers.

Inlet Sensor (deg C) Measures the current inlet temperature on the card. The inlet sensor is on the line

cards, GRP card, clock and scheduler cards, switch fabric cards, and power

supplies.

48V (Volt) Measures the DC power supplies.

AMP_48 (Amp) Measures the AC power supplies.

Fan 0, Fan 1, Fan 2 Measures the fan speed in rotations per minute.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco 12012 Technical Information Seite 48

Kommentare zu diesen Handbüchern