Cisco TANDBERG?150MXP Bedienungsanleitung PDF herunterladen (Seite 46)

TANDBERG TANDBERG and Cisco CallManager

D13907.01

10 TANDBERG Management Suite and Cisco CallManager

TANDBERG Management Suite (TMS) is a web-based management system primarily used for

controlling, scheduling, upgrading and maintaining H.323 and H.320 units. However, with TMS 11, TMS

is now capable of supporting upgrades of the TANDBERG MXP endpoints for Cisco CallManager. In a

Cisco CallManager environment the CallManager manages all the SCCP endpoints. The CallManager

uses TFTP to upgrade the SCCP endpoints; the TANDBERG MXP systems for CallManager do not

support upgrade over TFTP and can therefore not be upgraded via the Cisco CallManager, thereby

creating a void between the video systems and the IP telephones located in an enterprise; TMS fills this

void.

Note: TMS has a scheduling function that makes it possible to schedule calls from TANDBERG H.323

devices TMS do not support scheduling of SCCP units, but it is possible to include them in a scheduled

call from a TANDBERG H.323 device.

11 Summary

This document described how to configure the CallManager for registration of TANDBERG MXP

endpoints for Cisco CallManager, and what software is needed on the CallManager to be able to do this. It

also described how to register a TANDBERG H.323 endpoint to the Cisco CallManager.

Registering the TANDBERG H.323 endpoint to the CallManager will give several limitations compared

to TANDBERG H.323 endpoints that is registered to a Gatekeeper, the reason for this is that the

CallManager only supports for H.323 version 2. In a call between two H.323 units this will cause some of

the H.323 version 4 and 5 features to fail. To be able to keep all the H.323 features in a call between two

H.323 endpoints and still be able to place calls between a SCCP unit and a H.323 unit you have to register

all the H.323 units to a Gatekeeper and make link between the H.323 network and the SCCP network.

This document showed you how to do this by configuring the CallManager with an H.225 trunk and

registering it to a Gatekeeper.

Once the CallManager has registered a trunk to the Gatekeeper it will be possible to place calls between

all the TANDBERG H.323 units and the units in the CallManager Network, this means that the SCCP

endpoint can use several of the recourses on the H.323 network. In this document it has been described

how to configure the network to allow a SCCP endpoint to use resources on the TANDBERG Gateway,

TANDBERG MPS, TANDBERG MCU and the TANDBERG Expressway solution.

The last chapter in this document provided information on management of units on these two networks,

there are no software that can manage both the SCCP network and the H.323 network so the

recommendation is to use TMS to manage the H.323 equipment and use the Cisco CallManager to manage

the SCCP equipment.

1 2 ... 41 42 43 44 45 46

Keine Kommentare

Cisco TANDBERG?150MXP Bedienungsanleitung Seite 46