Chapter 2 Cisco 1710 Security Router Configuration
Configuring the Dialer Interface
2-6
Cisco 1710 Security Router Software Configuration Guide
78-12696-01
Statistics for Virtual Private Network (VPN) Module:
0 packets in 0 packets out
0 paks/sec in 0 paks/sec out
0 Kbits/sec in 0 Kbits/sec out
rx_no_endp: 0 rx_hi_discards: 0 fw_failure: 0
invalid_sa: 0 invalid_flow: 0 cgx_errors 0
fw_qs_filled: 0 fw_resource_lock:0 lotx_full_err: 0
null_ip_error: 0 pad_size_error: 0 out_bound_dh_acc: 0
esp_auth_fail: 0 ah_auth_failure: 0 crypto_pad_error: 0
ah_prot_absent: 0 ah_seq_failure: 0 ah_spi_failure: 0
esp_prot_absent:0 esp_seq_fail: 0 esp_spi_failure: 0
obound_sa_acc: 0 invalid_sa: 0 out_bound_sa_flow: 0
invalid_dh: 0 bad_keygroup: 0 out_of_memory: 0
no_sh_secret: 0 no_skeys: 0 invalid_cmd: 0
dsp_coproc_err: 0 comp_unsupported:0 pak_too_big: 0
pak_mp_length_spec_fault: 0
tx_lo_queue_size_max 0 cmd_unimplemented: 0
159405 seconds since last clear of counters
Interrupts: Notify = 0, Reflected = 0, Spurious = 0
cgx_cmd_pending:0 packet_loop_max: 0 packet_loop_limit: 512
This command can also be used as follows to verify that the VPN module is
disabled:
c1710#show crypto engine accelerator statistic
There is no crypto accelerator.
Configuring the Dialer Interface
Complete the following tasks to configure the dialer interface. Start in global
configuration mode.
Command Task
Step 1
interface dialer 0 Enter Dialer 0 interface configuration.
Step 2
ip address ip-address subnet-mask Set the IP address and subnet mask for the
Dialer 0 interface.
Step 3
ip mtu 1492 Set the size of the IP maximum transmission
unit (MTU).
Step 4
encapsulation ppp Set the encapsulation type to PPP.
Step 5
dialer pool 1 Specify the dialer pool to be used.
Kommentare zu diesen Handbüchern