Cisco 1710 Spezifikationen PDF herunterladen (Seite 61)

4-5

Cisco 1710 Security Router Software Configuration Guide

78-12696-01

Chapter 4 Configuring Routing Between VLANs with IEEE 802.1Q Encapsulation

IEEE 802.1Q Encapsulation Configuration Task List

Assigning an IP Address to a Network Interface

An interface can have one primary IP address. To assign a primary IP address and

a network mask to a network interface, use the following command in interface

configuration mode:

A mask identifies the bits that denote the network number in an IP address. When

you use the mask to subnet a network, the mask is then referred to as a subnet

mask.

Configuring IPX Routing over IEEE 802.1Q

IPX Routing over IEEE 802.1Q VLANs extends Novell NetWare routing

capabilities to include support for routing Novell Ethernet_802.3 encapsulation

frame types in VLAN configurations. Users with Novell NetWare environments

can configure Novell Ethernet_802.3 encapsulation frames to be routed using

IEEE 802.1Q encapsulation across VLAN boundaries.

To configure Cisco IOS software on a router with connected VLANs to exchange

IPX Novell Ethernet_802.3 encapsulated frames, perform these tasks in the order

in which they are appear:

• Enabling NetWare Routing

• Defining the VLAN Encapsulation Format

• Configuring NetWare on the Subinterface

Enabling NetWare Routing

To enable IPX routing on IEEE 802.1Q interfaces, use the following command in

global configuration mode:

Command Purpose

ip address ip-address mask

Sets a primary IP address for an interface.

Command Purpose

ipx routing [node]

Enables IPX routing globally.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 87 88

Keine Kommentare

Cisco 1710 Spezifikationen Seite 61