Cisco Catalyst 2900 Series XL Spezifikationen PDF herunterladen (Seite 46)

2-8

Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide

78-6511-06

Chapter 2 Getting Started with CMS

Front Panel View

Port Modes and LEDs

The port modes (Table 2-5) determine the type of information displayed through the port LEDs. When

you change port modes, the meanings of the port LED colors (Table 2-6, Table 2-7, and Table 2-8) also

change.

Note The bandwidth utilization mode (UTL LED) does not appear on the front-panel images. Select

Reports > Bandwidth Graphs to display the total bandwidth in use by the switch. Refer to the

switch hardware installation guide for information about using the UTL LED.

To select or change a mode, click the Mode button until the desired mode LED is green.

Table 2-5 Port Modes

Mode LED Description

STAT Ethernet link status of the 10/100, 100BASE-FX, or 1000BASE-X switch ports, or the Ethernet

link status on the remote customer premises equipment (CPE).

Default mode on all Catalyst 2900 XL and Catalyst 3500 XL switches except the

Catalyst 2900 LRE XL switches.

LRE

(Catalyst 2900 LRE XL

only)

Long-Reach Ethernet (LRE) link status of the LRE ports on the Catalyst 2900 LRE XL switches.

Default mode on these switches only.

Note When the LRE mode is active, the 10/100 switch ports on the Catalyst 2900 LRE XL

continue to show Ethernet link status.

FDUP or DUPLX Duplex setting on the ports.

• Default setting is auto on all Catalyst 2900 XL and Catalyst 3500 XL switches and on the

10/100 ports on the Catalyst 2900 LRE XL switches.

• Default setting is half-duplex on the LRE ports on the Catalyst 2900 LRE XL switches.

Note On the Catalyst 2900 LRE XL switches, this LED shows the duplex mode used on the

Ethernet link between the remote CPE and Ethernet device.

SPEED or SPD Speed setting on the ports. Default setting is auto.

Note On the Catalyst 2900 LRE XL switches, this LED shows the link speed between the

remote CPE and Ethernet device.

LINE PWR

(Catalyst 3524-PWR XL

only)

Inline power setting on the Catalyst 3524-PWR XL 10/100 ports. Default setting is auto.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 321 322

Keine Kommentare

Cisco Catalyst 2900 Series XL Spezifikationen Seite 46