Cisco TES301 Betriebsanweisung PDF herunterladen (Seite 56)

Chapter 3 Configuration and Operation of the TES301

36 4038767 Rev A

 If yes, choose STUN or Port Mapping from the NAT Traversal Mode drop-

down menu; then, continue with the next step.

Note: Use the scroll bar to access all of the fields on this screen.

3 If you selected the STUN option, complete the following steps:

a STUN Server Address—Enter the address of a STUN server running on

public network. Your device will send a discover request to the STUN server

and decide NAT mode based on the response message from the STUN

server.

b STUN Server Port—Specify the port for the STUN server. Your device will

send a discover request to the STUN server via the specified port.

c NAT Keep Alive Interval—Enter the number of seconds to indicate the

interval for your device to send discover requests to keep NAT traversal

active.

d Skip to step 5 to continue.

4 If you selected the Port Mapping option, complete the following steps:

a External Router Address—Enter the external router address.

b External SIP Signal Port—Enter the external SIP signal port used to

communicate with SIP agent in public network.

c External Base RTP Port—Enter the external RTP stream port used to

communicate with SIP agent in public network.

5 Complete the following steps to configure Codec Settings:

a From the Disabled Codec list, select a Codec you want to enable.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 97 98

Keine Kommentare

Cisco TES301 Betriebsanweisung Seite 56