Cisco Aironet 1000 Series Installationsanleitung Seite 10

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 28
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 9
10
Make sure that your network infrastructure devices are operational and properly configured.
Verify that the wireless LAN controllers are connected to switch trunk ports.
Ensure that a DHCP server with Option 43 configured is reachable by your access points.
Ensure that access points are not mounted closer than 7.9 in. (20 cm) from the body of all persons.
Do not mount the access point within 3 ft (91.4 cm) of metal obstructions. Refer to the Cisco
Aironet 1000 Series Lightweight Access Point Deployment Guide for additional information.
Install the access point away from microwave ovens. Microwave ovens operate on the same
frequency as the access point and can cause signal interference.
Always mount the access point vertically (standing up or hanging down).
Do not mount the access point outside of buildings.
Do not mount the access point on building perimeter walls unless outside coverage is desired.
When mounting an access point in the corner of a right-angle hallway intersection, mount the
access point at a 45-degree angle to the two hallways (see Figure 5). The access point internal
antennas are not omnidirectional and cover a larger area when mounted this way.
Figure 5 Mounting the Access Point in a Hallway Intersection
Ensure that the access point is on the same subnet as the primary, secondary, or tertiary controllers
or has a DHCP server on the subnet with a route to the controllers.
External antennas must be mounted indoors only. Do not install external antennas outdoors.
Deploying the Access Point on the Wireless Network
Follow these steps to deploy one or more access points on the wireless network:
Step 1 Obtain the access point location map created during your site survey.
Step 2 Review the access point locations and identify specific mounting methods for each location.
Step 3 Ensure that a DHCP server is enabled on the subnet (typically on your switch). The access
points receives its IP address using DHCP Option 43.
135660
Seitenansicht 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare