Cisco 4430 Bedienungsanleitung PDF herunterladen (Seite 3)

3-3

Cisco Content Routing Software Configuration Guide and Command Reference

78-12685-01

Chapter 3 Maintaining the Content Routing Software

Upgrading the Software

Note If you have not saved your most recent configuration to Flash memory (NVRAM), you will

be asked to do so before rebooting the Content Router.

If you want to stop the auto-boot process to change default boot parameters, perform the following steps

(console connection only):

Note In the example, the Content Router boot device parameter is changed from net to flash.

a. Press any key during the auto-boot sequence.

b. Enter c at the prompt to change the auto-boot settings.

c. At the boot device prompt, enter flash.

This ensures that the Content Router boots from Flash memory rather than from a system image

resident on another network host.

d. At the filename prompt, press Ctrl-D to quit the change-default-boot-parameter sequence.

e. At the console prompt, enter @.

For example:

Press any key to stop auto-boot...

[CE500 Series]: c

'.' = clear field; '-' = go to previous field; ^D = quit

boot device (flash,net) [ net]: flash

filename [ ]: ^D

. . [CE500 Series]: @

Step 6 When the boot process is complete, verify the software version with the show version command:

console# show version

Cisco Content Router

Software Release: CR ver 1.1 (Build: #1 03/30/01)

Compiled: 13:47:15 Mar 26 2001 by morlee

Image text-base 0x108000, data_base 0x392244

System restarted by Reload

The system has been up for 0 weeks, 0 day, 0 hours, 1 minutes, 10 seconds.

System booted from "flash"

1 2 3 4 5 6 7 8 ... 11 12

Keine Kommentare

Cisco 4430 Bedienungsanleitung Seite 3