Cisco 2501 - Router - EN Bedienungsanleitung Seite 21

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 76
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 20
Command-Line Interface (CLI)
199
Gathering Basic Routing Information
The show version command will provide basic configuration for the system hardware as well
as the software version and the boot images. Here’s an example:
yourname#show version
Cisco IOS Software, 2800 Software (C2800NM-ADVSECURITYK9-M), Version
12.4(12), RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Fri 17-Nov-06 12:02 by prod_rel_team
The preceding section of output describes the Cisco IOS running on the router. The following
section describes the read-only memory (ROM) used to boot the router and hold the POST:
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
The next section shows how long the router has been running, how it was restarted (if you
see a system restarted by bus error, that is a very bad thing), where the Cisco IOS was
loaded from, and the IOS name. Flash is the default:
yourname uptime is 2 hours, 30 minutes
System returned to ROM by power-on
System restarted at 09:04:07 UTC Sat Aug 25 2007
System image file is "flash:c2800nm-advsecurityk9-mz.124-12.bin"
This next section displays the processor, the amount of DRAM and flash memory, and the
interfaces the POST found on the router:
[some output cut]
Cisco 2811 (revision 53.50) with 249856K/12288K bytes of memory.
Processor board ID FTX1049A1AB
2 FastEthernet interfaces
4 Serial(sync/async) interfaces
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
62720K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
The configuration register value is listed last—it’s something I’ll cover in Chapter 5.
In addition, the show interfaces and show ip interface brief commands are very
useful in verifying and troubleshooting a router as well as network issues. These commands
are covered later in this chapter. Don’t miss it!
47020.book Page 199 Wednesday, January 2, 2008 4:31 PM
Seitenansicht 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare