Cisco BayTech DS Series Bedienungsanleitung PDF herunterladen (Seite 6)

DS62-MD4 Network/Modem Host Module

Coldfire login: root

Password:

The default user and password is “root/baytech”, all lower case.

Manage Users

This menu allows the administrator to add/delete users and change their passwords for multiple users.

Up to 19 users plus an administrator allowed. Usernames and passwords are case sensitive and

alphanumeric. The root user can not be removed. Select Manage User and the DS displays the

following:

Figure 4

Radius Configuration

Radius is used to authenticate logins for the serial and the network ports if passwords and user names

are enabled on the DS. If the Radius server rejects either the username or password or does not

respond, the DS will display “Invalid Password”.

TACACS Configuration

TACACS can be used to authenticate logins for the serial port, the network port, and modem. When a

telnet / SSH session (or rs232 session) is started the Host module will prompt for the username and

password. The Host will communicate with the TACACS server. If the server verifies the username

and password, the Host will display the menus. If the server rejects the username and password or

does not respond the Host will display the reason why the login failed.

Network Port Configuration

IMPORTANT: For network access, enable Telnet and configure the IP addresses, Subnet

Mask, and Gateway Address, or enable the DHCP. The module must be reset for network

changes to take effect.

User Management Menu

To change user password or port access, enter number of user.

To add/delete user, select appropriate menu choice.

SNMP V3 requires passwords that are between 8 and 31 characters long

Enter request, CR to exit menus.

A)...Add user

1)...root

Enter Request :

1 2 3 4 5 6 7 8 9

Keine Kommentare

Cisco BayTech DS Series Bedienungsanleitung Seite 6