Cisco DMP100 Betriebsanweisung PDF herunterladen (Seite 14)

2. Field calibration

(1)

(2)

(3)

(5)

(4)

Image 2-3

4. Field adjust

- (1) Click on Field Adjust tab

- (2) Press “Backup/Restore LMT Data” to back up LMT data of the desired tiles/frames in the pop up dialog.

- (3) Input tile address in text, and click the frame number in “select frame” , the selected one in red colored, is positioned on

LED wall with outline too. Check if the desired frame is selected.

- (4) Press “Read” in “LMT Data” frame, x, y,and Y value is shown in the table.

- (5) Input new LMT value in the text below “Y (modify)”

- (6) Select the desired calibration level in “Calibration Simulation” frame

- (7) Next press “Simulate” and view the effect on LED wall;

- (8) If simulation effect is OK, press “Modify” to modify the raw LMT data w

ith this new value. If NOT OK, repeat step (5) ~ (7)

again

(1)

(2)

(3)

(4)

(5)

(4)

(6)

(7)

(8)

Image 2-4

conﬁguration

WARNING: Mu st backu p LMT data before m odify it. When LMT data is badly modiﬁed, p ress “Bac kup/Restore

LMTDatatorestoretherawLMT

data in the pop up dialog .

10 R59770395 FIELD CALIBRATION SOFTWARE (FCS-100) 08/05/09

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Keine Kommentare

Cisco DMP100 Betriebsanweisung Seite 14