Cisco 2650 - 2650 Router Bedienungsanleitung

Helsinki University of Technology Department of Communications and Networking How to Configure Cisco 2600 Routers

10 • area OSPF area parameters • auto-cost Calculate OSPF interface cost according to bandwidth • capabilit

11 If no OSPF router ID is explicitly configured, OSPF computes the router-ID based on the items 2, 3, and 4 and restarts OSPF (if the process is

12 ip ospf transmit-delay seconds Set the estimated number of seconds it takes to transmit a link state update packet on an OSPF interface. ip ospf

13 2.3 RIP and OSPF Redistribution 2.3.1 RIP If you like to redistribute routing information to OSPF, you have to tell RIP running router process-

14 3 Configure CEF Load balancing is based on a combination of source and destination packet information; it allows you to optimize resources

15 References [1] Cisco: Configuring RIP http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/np1_c/1cprt1/1crip.pdf [2] Cisco: C

2 Table of Contents Purpose ...

3 Purpose Purpose of this document is to show how to use and configure Cisco 2600 Series routers. Mainly this document has been done f

4 1 Cisco Inter-network Operating System (IOS) 1.1 Cisco IOS Operation Modes The Cisco Software provides access to four different command modes. T

5 Router#Router>Router(config)#Router(config-if)#enableconfigureterminalinterface etc.exitexit, end, Ctrl-Zdisableexit, end, Ctrl-Z Figure 1. Fou

6 routing is enabled by default. To disable IP routing, enter the no ip routing command and enter ip routing to re-enable it. 1.2 Getting Help In a

7 1.4 Configuration System (Setup) In privileged EXEC mode you can setup the whole system, for example setup network cards, put IP addresses, start

8 2 Routing Protocol Configuration 2.1 Routing Information Protocol RIP You can modify RIP routing by giving the next command in global

9 Table 2. RIP version commands in sending. Command Purpose ip rip send version 1 Configure an interface to send only RIP version 1 packets.