Cisco OSM-12CT3/T1 - Optical Services Module Multiplexor Installationsanleitung PDF herunterladen (Seite 12)

Chapter 1 Product Overview

Supervisor Engines

1-12

Cisco 7600 Series Internet Router Module Installation Guide

78-12798-07

Note EIA/TIA-232 and EIA/TIA-449 were known as recommended standards

RS-232 and RS-449 before their acceptance as standards by the Electronic

Industries Alliance (EIA) and Telecommunications Industry Association

(TIA).

For detailed information on using this port, see the “Connecting to the Console

Port” section on page 3-15.

Console Port Mode Switch

The console port mode switch allows you to connect a terminal to the

supervisor engine using either the console cable and adapters provided with

the Cisco 7600 series Internet Router or the console cable provided with a

Catalyst 5000 family Supervisor Engine III.

You also can connect a modem to the console port using the cable and adapter

provided with the system.

Note To access the port mode switch, use a ballpoint pen tip or other small, pointed

object.

To connect a terminal, use the port mode switch as follows:

• Mode 1—Switch in the in position (factory default). Use this mode to connect

a terminal to the console port using the console cable and DTE adapter

(labeled “Terminal”) that shipped with the system.

You can also use this mode to connect a modem to the console port using the

console cable and DCE adapter (labeled “Modem”) that shipped with the

system.

• Mode 2—Switch in the out position. Use this mode to connect a terminal to

the console port using the Catalyst 5000 family Supervisor Engine III console

cable (not provided).

For more information on using the console port, see the “Connecting to the

Console Port” section on page 3-15.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Keine Kommentare

Cisco OSM-12CT3/T1 - Optical Services Module Multiplexor Installationsanleitung Seite 12