Cisco 4305G Betriebsanleitung PDF herunterladen (Seite 40)

Getting Started Guide for Cisco Digital Media Players

78-19212-02

Configure Settings

Step 6 If you chose 3M, Zytronic, or another driver that must be calibrated manually:

a. After your DMP has restarted, log in again to DMPDM.

b. Click Touch Screens in the Settings list.

c. Click Calibrate <driver_name> Screen, where driver_name is the name of the driver that

you chose.

• Messages on the touchscreen prompt you to touch its surface in various places. Follow these

prompts exactly. For example, the calibration utility might prompt you to touch exactly five

areas or exactly nine areas.

• Time is limited. When you do not complete this exercise within the brief period that is allotted

for it, the calibration utility times out automatically.

• Repeat these steps for manual calibration if the driver utility times out before you can finish.

Note You must repeat the calibration whenever you:

• Rotate a touchscreen or change its resolution.

• Replace a touchscreen.

Step 7 Stop. You have completed this procedure.

Related Topics

• Connect to a Touchscreen, page 27

Configure NTP Settings for Time-Dependent Features

IP-enabled devices including DMPs can use network time protocol (NTP) to synchronize themselves

with radio and atomic clocks located on the Internet. Thus, the accuracy of their local time-keeping is

ensured. NTP can synchronize distributed clocks within milliseconds over long time periods. You must

configure NTP settings on any DMP through which you will provide:

• IPTV services with Cisco Cast.

• Proof-of-play services with Cisco Digital Signs.

• Any other service that is dependent upon accurate Start and Stop times.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

Keine Kommentare

Cisco 4305G Betriebsanleitung Seite 40