Cisco SIEMENS HICOM 330E Bedienungsanleitung PDF herunterladen (Seite 3)

Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com

Page 3 of 24

Software Requirements

 Cisco Unified CallManager Release 4.0

 Siemens PBX software 3.1

Features

Key Features Supported

 Calling Number Identification Presentation

Key Features Not Supported

 Calling/Connected Name delivery is not supported by the Siemens Hicom 330E PRI Interface with ETSI protocol

 Sending Connected Number is not supported by Cisco Unified CallManager 4.0 PRI trunk

Configuration

Configuration Sequence and Tasks

1. Add the new access code to Dialing Plans using WABE + LDPLN.

2. Add the new trunk board using BCSU.

3. Configure Class of Trunk using COT.

4. Configure Class of Parameter for device handler using COP.

5. Configure Class of Service using COSSU.

6. Add the new trunk group access code using BUEND.

7. Configure trunk using TDCSU.

8. Configure Reference Clock using REFTA.

9. Configure trunk Least Cost Routing using LDAT + RICHT.

10. Configure LCR Out-dial Rules using LODR.

Configuration Menus and Commands

Configuring the Siemens 300E PBX

DPLN

<DISPLAY-WABE:TYPE=GEN;

DIS-WABE:GEN;

H500: AMO WABE STARTED

------------------------------------------------------------------------------

| DIGIT INTERPRETATION VALID FOR ALL DIAL PLANS |

------------------------------------------------------------------------------

------------------------------------------------------------------------------

| 001 - 003 |* ..... ..... ..... ..... ..| NETRTE | |

| 004 |* ..... ..... ..... ..... ..| NETRTE | R |

| 005 - 006 |* ..... ..... ..... ..... ..| NETRTE | |

| 1000 |. .**** ***** **... ..... ..| STN | |

| 11 |. ..... ..... ..... ....* ..| MBKY | |

| 111 |. .**** ***** **... ..... ..| TIE | |

| 222 |. .**** ***** **... ..... ..| OWNNODE | |

| 3000 |. .**** ***** **... ..... ..| STN | |

Cisco SIEMENS HICOM 330E Bedienungsanleitung Seite 3