Cisco UCS C200 Spezifikationen PDF herunterladen (Seite 30)

Send document comments to ucs-docfeedbac[email protected]

2-12

Cisco UCS C200 Server Installation and Service Guide

OL-20732-02

Chapter 2 Installing the Server

Initial Server Setup

NIC Modes and NIC Redundancy Settings

This server has the following NIC mode settings that you can choose from:

• Dedicated—The two 10/100 management ports are used to access the CIMC. You have to select a

NIC redundancy and IP setting.

• Shared LOM (default)—The two 1Gb Ethernet ports are used to access the CIMC. This is the factory

default setting, along with Active-active NIC redundancy and DHCP enabled.

• Cisco Card—The ports on an installed Cisco network adapter card are used to access the CIMC. You

have to select a NIC redundancy and IP setting.

Note The Cisco Card NIC mode is currently supported only with a Cisco UCS P81E Virtual Interface

Card (N2XX-ACPCI01) that is installed in PCIe slot 2 (see

Figure 3-15 on page 3-27). See also

Special Considerations for the Cisco UCS P81E Virtual Interface Card (N2XX-ACPCI01),

page 3-27.

This server has the following NIC redundancy settings that you can choose from:

• None—The Ethernet ports operate independently and do not fail over if there is a problem.

• Active-standby—If an active Ethernet port fails, traffic fails over to a standby port.

• Active-active—All Ethernet ports are utilized simultaneously.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 103 104

Keine Kommentare

Cisco UCS C200 Spezifikationen Seite 30