Cisco UCS B200 M3 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 27)

Cisco UCS B200 M3 Blade Server Installation and Service Note

OL-26624-01

Working Inside the Blade Server

Caution On certain models, heat sinks are keyed to fit into the plastic baffle extending from the motherboard. Do

not force a heat sink if it is not fitting well, rotate it and re-orient the heat sink.

Step 10 Secure the heat sink to the motherboard by tightening the four captive screws a quarter turn at a time in

an X pattern as shown in the upper right of Figure 17.

Installing Memory

To install a DIMM into the B200 M3 blade server, follow these steps:

Step 1 Open both DIMM connector latches.

Figure 19 Installing DIMMs in the Blade Server

Step 2

Press the DIMM into its slot evenly on both ends until it clicks into place.

DIMMs are keyed, if a gentle force is not sufficient, make sure the notch on the DIMM is correctly

aligned.

Step 3 Press the DIMM connector latches inward slightly to seat them fully.

331373

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Keine Kommentare

Cisco UCS B200 M3 Anleitung zur Fehlerbehebung Seite 27