Cisco Remote Control Betriebsanweisung PDF herunterladen (Seite 11)

What If None of the Codes Work?

If none of the codes listed for your brand of device operate the device correctly,

you can search through the code library for a valid code.

Improving Your Reaction Time

When you search the code library, you need to be ready to press SELECT as

soon as the remote turns o your device. Therefore, make sure you are familiar

with the location of the SELECT key before you begin this procedure.

Sizing Up the Libraries

The mode keys blink twice when the remote reaches the last code in a library.

You do not need to count codes. However, knowing the size of each library will

help you determine how long it will take to cycle through all of the codes in the

library. Each library contains the following number of codes:

• CBL mode: 45 • TV mode: 352 • DVD mode: 229

• VCR mode: 122 • SAT mode: 53 • AUDIO mode: 133

• CD mode: 26

Searching the Code Library (Program Code 9 9 1)

1. Turn on the device.

2. Press and hold SELECT and the appropriate mode key (CBL, TV, VCR, DVD,

or AUX) until the mode keys blink twice. For example, to search for a TV

code, press and hold SELECT and TV at the same time.

Note: If you reassigned mode keys, you may, for example, press SELECT

and VCR to search for a TV code to assign to the VCR mode key.

3. Press 9 9 1. The mode key you selected in step 2 blinks twice.

4. Point the remote toward the device, and press PLAY . The remote

automatically tests each code in its library, beginning with the most common

codes. The mode key blinks once each time the remote transmits a new

code. All mode keys blink three times when it reaches the last code.

5. As soon as the device powers o , press SELECT.

6. Verify the new code is correct by pressing POWER.

7. Did the device power on again?

• If yes, press SELECT to assign the code.

• If no, complete the following steps:

a) Turn the device on.

b) Press or to step forward or back to the correct code.

c) When the device turns o , press SELECT to assign the code.

8. Go to Which Code Worked to identify the code that controls your device.

After you identify the code, record the code in the space provided on the

cover of this guide.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Keine Kommentare

Cisco Remote Control Betriebsanweisung Seite 11