Cisco NPE-G2 - Network Processing Engine G2 Installationsanleitung PDF herunterladen (Seite 34)

7-34

Network Processing Engine and Network Services Engine Installation and Configuration

OL-4448-08

Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information

Installing the NPE-G1 or NPE-G2

You have finished installing the cable-management brackets. Go to the “Reconnecting Input Power and

Powering Up the Router” section on page 7-35.

Installing the Default Cable-Management Bracket on a Cisco uBR7246VXR Router (Optional)

If you are not using the NPE-G1 cable-management bracket, you can alternatively use two

cable-management bracket configurations for the Cisco uBR7246VXR router. In the first configuration,

for a 4-post rack, the rack-mount brackets are installed at the rear of the chassis and the

cable-management bracket is installed at the right front of the chassis. (See Figure 7-22 on page 7-34.)

You must install both sets of brackets before you install the chassis in the rack.

In the second configuration, for a telco-type rack, the rack-mount brackets are installed at the middle of

the chassis and the cable-management bracket is installed at the right front of the chassis. (See

Figure 7-23 on page 7-35.) You must install both sets of brackets before you install the chassis in the

rack.

Note The cable-management bracket must be installed on the right side of the chassis when viewed from the

front.

Figure 7-22 Installing the Chassis in a 4-Post Rack with an Installed Cable-Management Bracket

1 Rack-mount bracket 2 Cable-management bracket

93812

1 2

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 65 66

Keine Kommentare

Cisco NPE-G2 - Network Processing Engine G2 Installationsanleitung Seite 34