Cisco GRP Bedienungsanleitung PDF herunterladen (Seite 4)

Configuring POTS Dial Peers

This topic describes how to configure POTS dial peers.

Cisco Public

IP Telephony

POTS Dial Peers

Before the configuration of Cisco IOS dial peers can begin, the user must have a good

understanding of where the edge devices reside, what type of connections need to be made

between these devices, and what telephone numbering scheme is applied to the devices.

Follow these steps to configure POTS dial peers:

How to Configure POTS Dial Peers

Step Action

1. Configure a POTS dial peer at each router or gateway where edge telephony devices connect

to the network.

2. Use the destination-pattern command in the dial peer to configure the telephone number.

3. Use the port command to specify the physical voice port that the POTS telephone is

connected to.

The dial-peer type will be specified as POTS because the edge device is directly connected to a

voice port and the signaling must be sent from this port to reach the device. There are two basic

parameters that need to be specified for the device: the telephone number and the voice port.

When a PBX is connecting to the voice port, a range of telephone numbers can be specified.

1 2 3 4 5 6 7 8 9 ... 35 36

Keine Kommentare

Cisco GRP Bedienungsanleitung Seite 4