Cisco WS-X6748-SFP - Switch Spezifikationen

Products & Services Cisco Small Form-Factor Pluggable (SFP) Transceiver Modules Maintenance and Troubleshooting Document ID: 72370 Introduction

3. Check the label on the SFP transceiver body to verify that you have the correct model for your network. 4. Find the send (TX) and receive (RX) mark

{ The LED turns green when the SFP transceiver and the target device have an established link. { The LED turns amber while STP discovers the network t

index finger, and carefully remove it from the socket. 4. Place the removed SFP transceiver in an antistatic bag or other protective environment. Ca

Configure SFPs Configure Interface Speed and Duplex Mode Ethernet interfaces on the switch operate at 10, 100, or 1000 Mbps, or 10,000 Mbps and in e

1. Disable port negotiation on the port. 2. Enable port negotiation on the port to bring the links UP. The set port negotiation command enables or dis

If only GE ports are selected for uplink: If both 10GE and GE ports are selected for uplink: Issue these commands in order to enable the 10-Gigabit Et

connectors can be active for a port and the active connector is determined by the interface configuration command media-type {rj45 | sfp}. In a WS-X

Contacts | Feedback | Help | Site Map Related Information z Cisco 100-Megabit Ethernet SFP Modules Compatibility Matrix z Cisco Gigabit Ethernet T

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a c

SFP Transceiver Module [Fiber-Optic LC Connector] 1000BASE-T SFP Transceiver Module [RJ-45 Connector] Cisco Gigabit Ethernet SFPPart NumberDescrip

1Without Digital Optical Monitoring (DOM) 2With Digital Optical Monitoring (DOM) 3 NEBS 3 ESD For more information about support for Gigabit Ethernet

Supported Catalyst Switches This section lists the Cisco Catalyst Switches that support the Cisco SFP Transceiver Modules. Note: If a module / device

Catalyst 3750 Series Catalyst 3750-E Series Catalyst 3560 Series Catalyst 3560-E Series WS-X4013+10GE-GLC-LH-SM GLC-ZX-SM GLC-BX-D GLC-BX-UAll CWD

Catalyst 2970 Series Catalyst 2960 Series Catalyst 2950 Series Catalyst 2948G Series Catalyst 2940 Series Catalyst Express 500 Series Refer to t

z Cisco Wavelength Division Multiplexing Transceivers Compatibility Matrix Safety Guidelines Laser Safety Before you install SFP modules in a Cisco

Note: See the Safety Guidelines section before you install the SFP Transceiver Modules. Types of SFP Transceiver Latches SFP Transceiver Modules can