Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Installationsanleitung PDF herunterladen (Seite 84)

Chapter 2 Installing and Starting the Switch

Connecting to the GBIC Module Ports

2-38

Catalyst 3550 Multilayer Switch Hardware Installation Guide

78-11358-03

Step 6 Repeat Steps 1 through 5 to connect each port.

Connecting to the GBIC Module Ports

These sections describe how to connect to a GBIC module port. For detailed

instructions on installing, removing, and cabling a GBIC (1000BASE-X module,

1000BASE-T module, or the GigaStack module), refer to your GBIC

documentation.

Connecting to a 1000BASE-X GBIC Module Port

Caution Do not remove the rubber plugs from the fiber-optic port or the rubber caps from

the fiber-optic cable until you are ready to connect the cable. The plugs and caps

protect the fiber-optic port and cable from contamination and ambient light.

Avoid exposure to the laser beam.

Follow these steps to connect to the 1000BASE-X GBIC port:

Step 1 Remove the rubber plugs from the fiber-optic port on the module, and store them

for future use.

Step 2 Insert the SC connector in the fiber-optic receptacle, as shown in Figure 2-36.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 149 150

Keine Kommentare

Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Installationsanleitung Seite 84