Cisco Wireless Express 526 Bedienungsanleitung PDF herunterladen (Seite 2)

How to configure Cisco WLC(Wireless Controller) 526?

Written by CiscoNET

Wednesday, 06 May 2009 09:15 - Last Updated Sunday, 26 July 2009 23:43

Simple we divided three VLANs for few reasons such as security and reduced

unnecessary traffic on each network boundary

• VLAN 20 = Guest Network (Who can access Internet / but not Intranet)

• VLAN 30 = User Network (Who can access Internet and Intranet)

• VLAN 40 = AP-manager Network (Network for Cisco WLC526 and AP521)

There are two ways to configure Cisco 500 Series Wireless Express Mobility

gears : GUI and Console mode.

Cisco recommends a using "Cisco Configuration Assistant" for initial

configuration, but I preferred to use console mode, not just b/c I am used to it.

Some of terminology used in the box easily make you confused, while you are

setting up WLC(Cisco Wireless Controller) 526.

• Management VS. AP-manager interface : Very important to know that

Management interface means which you can access WLC 526 for modification ,

creation and apply. But AP-management interface is not for user. It is for AP521.

The interface is communicating to Cisco AP521s. You cannot access the Cisco

WLC526 using AP-manager interface IP.

• Cannot change VLAN tagging info by GUI configuration mode : If you didn't

specify VLAN number, while you were configuring the box using either GUI or

console mode, you cannot modify VLAN tag later. Make sure configuring VLAN

numbers.

• DHCP server for all VLANs : Don't forget DHCP server prepared for VLAN 20

2 / 8

1 2 3 4 5 6 7 8

Keine Kommentare

Cisco Wireless Express 526 Bedienungsanleitung Seite 2