Cisco PRP-1= Spezifikationen PDF herunterladen (Seite 51)

OL-17436-01

Configuring Interfaces on the PRP-3

DETAILED STEPS

Command or Action Purpose

Step 1

Install and configure the terminal

server.

Prepares the terminal server for communications with the router and with

Telnet clients.

• This step is usually preformed once.

• For router access, users need the Telnet server IP address and port

number for each RP they access.

• For additional information on configuring terminal services, including

terminal servers and templates, see the Cisco IOS XR System

Management Configuration Guide.

Step 2

Connect the terminal server to the

Console port of the target RP or DRP.

Establishes a communications path between the terminal server and the

router.

• During the initial router setup, you can communicate with the router

only through the Console port of the primary RP.

• The router Console port is designed for a serial cable connection to a

terminal or terminal server.

• The terminal settings are:

–

Bits per second: 9600/9600

–

Data bits: 8

–

Parity: None

–

Stop bit: 2

–

Flow control: None

• To enable terminal server connections to the Console ports on multiple

RPs and DRPs, install a cable between each Console port and the

terminal server.

Step 3

Power on the router. Starts the router.

• This step is required only if the router power is not on.

Step 4

Identify the target RP or DRP. Identifies the RP or DRP to which you connect in the next step.

• This step is not required when the router hosts only one RP or DRP.

• On a Cisco CRS-1 router, the active RP or DRP is identified by a

lighted Primary LED on the RP front panel.

• On a Cisco XR 12000 Series Router, the active RP is identified by the

alphanumeric display: ACTV RP.

• If you cannot look at the RPs, use a Management Ethernet interface

connection to determine which RP is active, or establish terminal

server connections to both RPs and then try both.

Step 5

telnet access-server-address port

Establishes a Telnet session with the terminal server.

• Replace access-server-address with the IP address of the terminal

server, and replace port with the terminal server port number that

connects to the target RP Console port.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco PRP-1= Spezifikationen Seite 51

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco PRP-1=