Cisco CISCO2821 Spezifikationen PDF herunterladen (Seite 16)

This document may be freely reproduced and distributed whole and intact including this Copyright Notice.

1. Clean the cover of any grease, dirt, or oil before applying the tamper evidence

labels. Alcohol-based cleaning pads are recommended for this purpose. The

temperature of the router should be above 10°C.

2. The tamper evidence label should be placed so that one half of the label covers

the front panel and the other half covers the enclosure.

3. The tamper evidence label should be placed over the CF card in the slot so that

any attempt to remove the card will show sign of tampering.

4. The tamper evidence label should be placed so that the one half of the label

covers the enclosure and the other half covers the port adapter slot.

5. The tamper evidence label should be placed so that the one half of the label

covers the enclosure and the other half covers the rear panel.

6. Place tamper evident labels on the opacity shield as shown in Figure 11.

7. The labels completely cure within five minutes.

Figures 9, 10 and 11 show the additional tamper evidence label placements for the 2811.

Figure 9 – 2811 Tamper Evident Label Placement (Back View)

Figure 10 – 2811 Tamper Evident Label Placement (Front View)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

Keine Kommentare

Cisco CISCO2821 Spezifikationen Seite 16