Cisco E2500 Bedienungsanleitung PDF herunterladen (Seite 15)

Revision 1.0 Page 15

®®

If the default values are used this should be 192.168.1.3. A message should be displayed at

the bottom left of the section stating that an IPG100 or N2KServer has been found, and giving

its IP Address.

Press the Connect button to establish the connection.

2.5 Adding a DSM800, TSM800, or TSM1330 N2KView

Client to the Network

Connect the DSM800/TSM800/TSM1330 to the WiFi/Router using an Ethernet Cable. The

cable plugs into one of the blue Ethernet sockets at the back of the router.

Open the Configuration Dialog on the DSM800/TSM800/TSM1330 by clicking on the

Configuration tab on the right of the screen. In the Network Configuration section, ensure that

the Use DHCP box is selected. If it is not, click on the square to display the check mark and

press the Update button. The screen may blank for a couple of minutes while the change is

applied.

Close the Configuration Dialog and open the Connections Dialog by clicking on the

Connections tab on the right of the screen.

In the N2KServer Connection section, press the Disconnect button, type the IP address of the

IPG100 or PC-based N2KServer.

If the default values are used this should be 192.168.1.3. A message should be displayed at

the bottom left of the section stating that an IPG100 or N2KServer has been found, and giving

its IP Address.

Press the Connect button to establish the connection.

2.6 Adding a Wired PC N2KView Client to the Network

Connect the PC to the WiFi/Router using an Ethernet Cable. The cable plugs into one of the

blue Ethernet sockets at the back of the router.

Using the Network Configuration tools supplied with the Windows Operating System, ensure

that DHCP is enabled.

Open the Connections Dialog by clicking on the Connections tab on the right of the screen.

In the N2KServer Connection section, press the Disconnect button, type the IP address of the

IPG100 or PC-based N2KServer.

If the default values are used this should be 192.168.1.3. A message should be displayed at

the bottom left of the section stating that an IPG100 or N2KServer has been found, and giving

its IP Address.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Keine Kommentare

Cisco E2500 Bedienungsanleitung Seite 15