Cisco 826 Bedienungsanleitung PDF herunterladen (Seite 3)

The router reboots, but ignores the saved configuration.

Type no after each setup question, or press Ctrl−C in order to skip the initial setup procedure.7.

Type enable at the Router> prompt.

You are in enable mode and should see the Router# prompt.

Type configure memory or copy startup−config running−config in order to copy the nonvolatile

RAM (NVRAM) into memory.

Important: Do not type copy running−config startup−config or write. These commands erase your

startup configuration.

Type show running−config.

The show running−config command shows the configuration of the router. In this configuration, the

shutdown command appears under all interfaces, which indicates all interfaces are currently shut

down. In addition, the passwords (enable password, enable secret, vty, console passwords) are in

either an encrypted or unencrypted format. You can reuse unencrypted passwords. You must change

encrypted passwords to a new password.

10.

Type configure terminal.

The hostname(config)# prompt appears.

11.

Type enable secret <password> in order to change the enable secret password. For example:

hostname(config)#enable secret cisco

12.

Issue the no shutdown command on every interface that you use.

If you issue a show ip interface brief command, every interface that you want to use should display

up up.

13.

Type config−register <configuration_register_setting>. Where configuration_register_setting is

either the value you recorded in step 2 or 0x2102 . For example:

hostname(config)#config−register 0x2102

14.

Press Ctrl−z or end in order to leave the configuration mode.

The hostname# prompt appears.

15.

Type write memory or copy running−config startup−config in order to commit the changes.16.

Example of Password Recovery Procedure

This section provides an example of the password recovery procedure. This example was created with a Cisco

2600 Series Router. Even if you do not use a Cisco 2600 Series Router, this output provides an example of

what you should experience on your product.

Router>enable

Password:

% Bad secrets

Router>show version

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600−IS−M), Version 12.0(7)T, RELEASE SOFTWARE (fc2)

Compiled Tue 07−Dec−99 02:21 by phanguye

Cisco − Password Recovery Procedure for the Cisco 806, 826, 827, 828, 831, 836, and 837 Series Routers

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco 826 Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco 826