Cisco 820 Series Installationsanleitung PDF herunterladen (Seite 4)

1-4

Cisco 820 Series and SOHO Series Router Cabling and Setup

78-13937-04

Chapter 1 Cisco 820 Series and SOHO Series Routers Cabling and Setup

Overview

This document describes the basic process of cabling and configuring the Cisco 827 series, and

Cisco 828 routers, the SOHO 77 series, and the SOHO 78 routers.

You can access the most current Cisco documentation on the World Wide Web at the following sites:

• http://www.cisco.com

• http://www-china.cisco.com

• http://www-europe.cisco.com

Parts List

The shipment of your router includes the following items:

• One Cisco 827, 827H, 827-4V, or 828 router, or one SOHO 77, 77H, or 78 router

• One yellow Ethernet cable

• One lavender ADSL cable

• One light blue console cable

• One black power supply

• One black power supply cord

• Cisco 800 and SOHO Series Product Documentation

If any of the items is missing or damaged, contact your customer service representative.

Connect the Router to a PC

Follow the steps shown in Figure 1-1 on page 1-5 to connect the router to a PC with an Ethernet network

interface card (NIC) installed. Figure 1-1 shows portions of two router back panels. Refer to the back

panel that is similar to the back panel of the router that you are installing.

Note Verify that the TO HUB/TO PC switch on the left side of the back panel has been set to the TO PC

position (out). If the button is in, press it to set it to the out position. You will know that the position is

correct if the LED for this port on the front of the router comes on after you have finished installing the

router and the PCs have been turned on.

To connect additional computers to Cisco 827H, Cisco 828, or SOHO 78 routers, obtain standard

Ethernet cables, and attach them to the router via Ethernet ports 1, 2, and 3.

1 2 3 4 5 6 7 8 9 ... 15 16

Keine Kommentare

Cisco 820 Series Installationsanleitung Seite 4