Cisco 7120-4T1 - 7120 Router Spezifikationen PDF herunterladen (Seite 105)

4-7

Cisco 7100 Series VPN Router Installation and Configuration Guide

78-6341-03

Chapter 4 Performing a Basic Startup Configuration

Configuring a Router

no ip directed-broadcast

duplex auto

speed auto

interface ATM1/0

ip address 10.1.1.2 255.255.255.0

ip broadcast-address 3.3.3.255

no ip directed-broadcast

shutdown

duplex auto

speed auto

interface Serial4/0

ip address 10.1.1.3

no ip directed-broadcast

shutdown

framing c-bit

cablelength 10

dsu bandwidth 44210

router igrp 200

network 10.0.0.0

end

Step 10 Save the settings to NVRAM.

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Your router is now minimally configured and ready to use. You can use the setup command if you want

to modify the parameters after the initial configuration. To perform more complex configurations, use

the configure command.

Performing a Basic Configuration Using Global Configuration Mode

You will need the following information before beginning the procedures in this section:

• Host name of the router and any passwords you plan to use

• Protocols you plan to route on each new interface

• IP addresses if you plan to configure the interfaces for IP routing

• Timing source for each new interface and clock speeds for external timing

The configure command requires privileged-level access to the EXEC command interpreter, which

usually requires a password. Contact your system administrator if necessary to obtain EXEC-level

access.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 175 176

Keine Kommentare

Cisco 7120-4T1 - 7120 Router Spezifikationen Seite 105