Cisco 30 VIP Spezifikationen Seite 38

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 44
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 37
38 VIP-FE-TX Installation and Configuration
FE-TX Port Adapter Functions
Note The configure command requires privileged-level access to the EXEC command interpreter,
which usually requires a password. Contact your system administrator, if necessary, to obtain
EXEC-level access.
Selecting Chassis Slot, Port Adapter, and Fast Ethernet Interface Port Numbers
The following section describes how to identify chassis slot, port adapter, and Fast Ethernet interface
port numbers.
Note Although the processor slots in the seven-slot Cisco 7000 and 13-slot Cisco 7513 are
vertically oriented and those in the five-slot Cisco 7010 and Cisco 7505 are horizontally oriented, all
models use the same method for slot and port numbering. (Refer to Figure 2, Figure 3, Figure 4,
Figure 5, or Figure 6 for interface processor slot orientation in your chassis.)
In the router, physical port addresses specify the actual physical location of each interface port on
the router interface processor end. (See Figure 23.) This address is composed of a three-part number
in the format chassis slot number/port adapter number/interface port number.
The first number identifies the chassis slot in which the VIP is installed (as shown in the example
system in Figure 23). The second number identifies the physical port adapter number on the VIP, and
is port adapter slot 0. The interface ports on the FE-TX port adapter is always numbered as
interface 0.
Note If you remove the VIP from slot 3 and install it in slot 2, the address of this port becomes
2/0/0.
Figure 23 Fast Ethernet Interface Port Number Example (Cisco 7505 Shown)
H5921
Slot 0
Slot 1
Slot 2
Slot 3
Interface
processor
slots
EJECT
SLOT 0
SLOT 1
NORMAL
CPU HALT
RESET
CONSOLE
ROUTE SWITCH PROCESSOR
AUX.
ENABLE
3/0/0 (FE-TX port adapter)
Note: The MII and RJ-45 interface ports on the first port adapter are both
numbered as interface port 0. Only one of them can
be used on each port adapter, at one time.
Seitenansicht 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare