Cisco 10008 Installationsanleitung PDF herunterladen (Seite 33)

The RJ-45 port on the PRE is configurable for 100-Mbps full-duplex or half-duplex operation (half-duplex is the default) and

supports IEEE 802.3, Ethernet, and IEEE 802.3u interfaces compliant with 100BASE-T specifications.

Follow these steps to connect the PRE to a 100BASE-T Ethernet LAN:

Figure 26 Connecting the 100BASE-T Cable to the Ethernet Port

Step 1 Connect one end of the Ethernet cable to the RJ-45 port on the primary PRE, labeled ETHERNET.

Step 2 Run the cable up and through the cable management bracket and connect the other end of the Ethernet cable to any

unoccupied port on the Ethernet hub.

Step 3 Check the LINK LED on the PRE faceplate (next to the ETHERNET port). This LED lights (green) if the PRE is

correctly connected to the 100BASE-T Ethernet LAN.

30036

CONSOLE

ETHERNET

LINK

AUX

SLOT 0

SLOT 1

CISCO

10000

LINK

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 47 48

Keine Kommentare

Cisco 10008 Installationsanleitung Seite 33