Cisco 10005 Installationsanleitung PDF herunterladen (Seite 28)

Cisco 10000 Series Router Performance Routing Engine Installation

OL-3971-03

Upgrading from an ESR-PRE or ESR-PRE1 to an ESR-PRE2

The router is available for normal operations and the upgrade is complete.

Saved the Configuration on a TFTP Server

If you booted the c10k2-p11-mz image, and you saved the previous configuration to a TFTP server:

a. Enter the initial configuration dialog, and enter all required information to allow access to the TFTP

server.

b. Assign the correct IP address for the Fast Ethernet interface to become active and for the TFTP

server to become reachable. This may require adding an IP route for the server even after the initial

dialog completes.

c. Restore the previous configuration from the TFTP server to the startup and running configuration on

the router.

d. Restore the startup and running configuration and update any boot commands to use the new

ESR-PRE2 (c10k2-p11-mz) image.

The router is available for normal operations and the upgrade is complete.

Did Not Save the Configuration

If you did not save the ESR-PRE2 image to either a TFTP server or a flash-based media card, and you

booted the helper (c10k-eboot-mz) image:

a. Enter the initial configuration dialog, and enter all required information. Be sure to assign the

correct IP address for the Fast Ethernet interface to become active and for the TFTP server to

become reachable.

b. The TFTP server should be reachable. If you wish to boot the ESR-PRE2 image from a local media

device, download the ESR-PRE2 (c10k2-p11-mz) image from the TFTP server to the local media

device (bootflash, disk0/1, or slot0/0). If you wish to boot directly from the TFTP server, you can

skip the image download.

c. Restore the previously saved configuration by downloading it from the TFTP server. Update any

boot commands from the previous configuration to point to the new ESR-PRE2 (c10k2-p11-mz)

image. Otherwise, update the boot command to point to the desired ESR-PRE2 image.

d. Reload the router. After reload, the router is available to resume normal operations and the upgrade

is complete.

Upgrading the Secondary PRE of a Redundant Pair of PREs to an ESR-PRE2

If you have a secondary, redundant ESR-PRE2 to install in the chassis, use the following procedure:

Step 1 Insert the second, redundant ESR-PRE2 into chassis slot B.

Step 2 Connect the terminal to the console port of the ESR-PRE2 in slot B. The console displays the ROM

monitor mode prompt (>).

Step 3 If you have a flash-based media card that contains the startup and running configuration and the

ESR-PRE2 image from your previous redundant ESR-PRE or ESR-PRE1:

a. Remove the flash-based media card from that ESR-PRE or ESR-PRE1 and insert it into the

ESR-PRE2 in slot B.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 45 46

Keine Kommentare

Cisco 10005 Installationsanleitung Seite 28