Cisco InfiniBand 4x Betriebsanweisung PDF herunterladen (Seite 69)

Chapter 4. Configuring InfiniBand with QLogic bridges 55

10.Click Configure to designate a name for the device as shown in Figure 4-27. This name

will be used later when mapping to an SRP Initiator.

Figure 4-27 Assign a name to the storage device

11.After you designate a name, click Submit. The remote drive moves from Discovered

Devices to Configured Devices (Figure 4-28).

Figure 4-28 Configured Storage Device

12.Close the FCP Device Discovery window and click SRP map config on the GUI main

menu page. Here, you see the virtual HBAs listed:

– If your virtual HBA was created on IOC 1, click the Click To Add link under the IOC 1

heading.

– If your virtual HBA was created on IOC 2, click the Click To Add link under the IOC 2

heading.

13.Give the map a name and select a map type, then click Next as shown in Figure 4-29 on

page 56. There are two mapping types:

–

Explicit: In an explicit mapping, the host and target LUN numbers must be listed in the

mapping.

–

Direct: In a direct mapping, the host sees all remote drives that are visible to the port

WWNs without a specific LUN being identified.

You address explicit mapping first, and then direct mapping.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 173 174

Keine Kommentare

Cisco InfiniBand 4x Betriebsanweisung Seite 69