Cisco 3750-48TS - Catalyst Switch - Stackable Installationsanleitung Seite 106

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 174
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 105
Chapter 2 Switch Installation
Installing and Removing XENPAK Modules
2-46
Catalyst 3750 Switch Hardware Installation Guide
OL-6336-01
Figure 2-41 Installing a XENPAK Module in the Catalyst 3750G-16TD Switch
Step 6 Secure the XENPAK module in place by tightening the two captive installation
screws. Do not overtighten the captive screws.
Removing a XENPAK Module
To remove a XENPAK module, follow these steps:
Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on
the chassis.
Step 2 Disconnect the cable from the XENPAK module. For fiber-optic modules, install
the optical bore dust plugs.
Step 3 Loosen the two captive installation screws that secure the XENPAK module in the
slot.
Step 4 Carefully pull on the two captive installation screws to disconnect the XENPAK
module from the slot.
1 Optical bore dust plug 2 Captive installation screw
Catalyst 3750
series
104573
2
1
TX
RX
1
Seitenansicht 105
1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 173 174

Kommentare zu diesen Handbüchern

Keine Kommentare