Cisco 7200 VXR Bedienungsanleitung PDF herunterladen (Seite 14)

Figure 8 Attaching the Rack-Mount Brackets to the Rear of the Chassis—Front Recessed

Brackets Rear-Mounted—Front Recessed in the Rack

Step 1 Locate the threaded screw holes in the rear sides of the chassis.

Step 2 Align a rack-mount bracket (1) to the threaded holes in the right side of the chassis.

Step 3 Using a Number 2 Phillips screwdriver and two M4 x 8-mm Phillips flathead screws (2), attach the rack-mount bracket

to the router.

Step 4 Repeat Step 2 and Step 3 for the bracket on the other side of the router. If you are not installing cable-management

brackets, skip to the “Two-Post or Four-Post Rack Installation” section on page 16 for rack-mount instructions.

Otherwise continue with Step 5.

Step 5 Align a cable-management bracket (3) to the threaded holes in the front of the chassis.

Step 6 Using two M4 x 8-mm Phillips flathead screws (4), thread and tighten the screws through the cable-management

bracket and into the chassis.

Step 7 Repeat Step 5 and Step 6 on the other side of the router.

If you have an NPE-G1 or NPE-G2 installed, go to the “NPE-G1 or NPE-G2 Rear Cable-Management Brackets on a

Rear-Mounted Router” section on page 15, or the “NPE-G1 or NPE-G2 Optical Cable-Management Bracket” section on

page 16.

If you do not have an NPE-G1 installed, go to the “Two-Post or Four-Post Rack Installation” section on page 16.

Rack-mount bracket

Cable-management bracket

M4 x 8-mm Phillips flathead screws

57003

T 10B

FAST SERIAL

ENABLED

MII

LINK

RJ45

FAST ETHERNET

OKE

N RIN

BLE

-R

6 M

bps

Cisco 7200

Series

T C

ENABLED

PCMCIA

EJECT

SLOT 0

ENABLE

FE LINK

CPU RESET

1O POWER

SLOT 1

FE MII

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco 7200 VXR Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Cisco 7200 VXR