Cisco 1751 Bedienungsanleitung PDF herunterladen (Seite 75)

C-9

Cisco 1751 Router Hardware Installation Guide

78-11258-04

Appendix C Installing and Upgrading Memory and Packet Voice Data Modules

Closing the Chassis

Step 5 Push the module towards the slot and press firmly until you hear a clicking sound,

and the module is firmly seated in the slot. Make sure that the snaps on both ends

of the PVDM are engaged. (See Figure C-4.)

Figure C-4 Installing a PVDM

Closing the Chassis

After installing memory or data modules on the motherboard, close the chassis by

following these steps:

Step 1 If you disconnected the fan from the motherboard as described in the “Opening

the Chassis” section, reconnect the fan cable to the connector labeled FAN on the

motherboard.

Step 2 Locate the posts that protrude from the inside of the chassis cover and the

corresponding openings on the chassis bottom.

Step 3 Line up the posts with the corresponding openings, as shown in Figure C-5, and

carefully slide the posts into the openings. Be careful not to damage the router

motherboard with the posts.

Step 4 Replace the screws that you removed when opening the chassis. (See Figure C-1.)

46570

PVDM module

PVDM snaps

PVDM slot

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 97 98

Keine Kommentare

Cisco 1751 Bedienungsanleitung Seite 75