Cisco DPA 7630 Bedienungsanleitung PDF herunterladen (Seite 7)

Cisco Digital PBX Adapter 7630 Release Notes

78-11319-01

DPA 7630 Known Problems and Errata

Documentation Errata

The following information was omitted from, or documented inaccurately in the

Cisco Digital PBX Adapter 7630 Administration Guide.

Setting No-Answer Timeout

The following section modifies page 3-13 of the Cisco Digital PBX Adapter 7630

Administration Guide.

When performing supervised transfers, the Octel system expects a certain number

of rings before the call forwards to voice mail. If the call forwards to voice mail

prematurely, the Octel system assumes the phone was busy.

To ensure that the Cisco CallManager system allows enough time for the number

of expected rings on the Octel system, you must set the no-answer timeout. In

Cisco CallManager, you should set this setting to be 6 seconds times the number

of rings. (Six seconds is slightly longer than the ring duration of a Lucent Definity

PBX system.) For example, if you have the Octel system set to four rings, set the

setting in Cisco CallManager to 24 seconds.

CSCds40475 Transfers from a Cisco IP

Phone to a PBX phone via the

DPA 7630 are routed directly

to voice mail.

The DPA 7630 functions properly in a Hybrid

configuration only if the Cisco CallManager has a

route plan that allows the Octel Voice Mail System

to make calls to a PBX system via the

Cisco CallManager.

For example:

• PBX directory numbers are 5XXX

• Cisco CallManager route plan is 8.XXXXX

In this case, you must create a route plan for the

Cisco CallManager that accepts the PBX pattern of

5XXX and allows the DPA 7630 to route the calls

over the digital link.

Table 1 DPA 7630 Known Problems (continued)

Bug ID Summary Explanation

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Cisco DPA 7630 Bedienungsanleitung Seite 7