
17
D14582.09 User guide Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300
All contents are copyright © 2010–2013 Cisco Systems, Inc. All rights reserved. Version TC6.0, 01.2013
Cisco TelePresence System Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300 User guide
www.cisco.com
Place a call to the rst
participant.
Call the next
participant in the usual
way.
To add another
one, tap (a)
followed by (b)...
Tap to place the second
call, initiating a conference. You
may adjust Call Settings before
you place the call, if needed.
Repeat the procedure from
, if
needed.
A maximum four video systems
(yourself included) and one audio call
may participate.
Tap END to terminate the
conference.
Creating a video conference
(Multiway
™
)
If your video system is equipped with the optional
Multiway feature you may call more than one to initiate
a video conference.
The maximum number of participants in a Multiway
conference depends entirely on the video
infrastructure implemented in your organization. If in
doubt, consult your System Administrator.
If you want to initiate a video conference, you must
call each participant one by one.
Note that the current call (or group of calls) must be
put on hold before you call the next participant.
. Those you call may have video systems
with dierent capabilities. One of them may, for
example, be on an ADSL system with limited bandwidth
(compared to the others). You may then set the Call
settings to a (normally lower) call rate suiting his or
her system before you call that person. However,
that call rate will aect that specic part of the video
conference only. Other participants will not experience
a lower call rate because of this.
See also the article Video conferencing—calling more
than one (optional)
on page 15.
If you initiated the conference you will be able to terminate the entire conference as well.
The other participants, however, may only disconnect themselves from the conference.
Kommentare zu diesen Handbüchern