Cisco 811 Installationsanleitung PDF herunterladen (Seite 8)

9 Connect the Power and Turn On the Router

Follow these steps to connect power to the Cisco 811 or 813 router and turn it on.

Figure 5 Connecting the Power to a Cisco 811 or 813 Router

Step 1 Make sure the router power is off. Press the power switch to standby ( ).

Step 2 Connect the desktop power supply cable to the 8-pin connector on the router.

Step 3 Connect the power cord to the desktop power supply.

Step 4 Attach the open loop connector of the ground conductor to the grounding terminal, then connect the power cord to an

electrical outlet.

Step 5 Turn ON the router. Press the power switch to on (|).

10 Verifying the LEDs

Verify the power connection and all other connections (links) by checking the LEDs in the table below. If the LEDs are not on,

see the troubleshooting information in the

Cisco 800 Series Router Hardware Installation Guide.

Power/Link LEDs To Check Normal Patterns

Power OK On

To hub, server, PC, or workstation Cisco 811 front panel: ETHERNET 1

Cisco 813 front panel: ETHERNET 4,

3, 2, and 1

To ISDN network using ISDN U port DSU, LINE, B1, or B2 On. B1 or B2 is on only when the router has

an active voice or data connection.

To ISDN network using ISDN S/T port LINE, B1, or B2 On.

B1 or B2 is on only when the router has

an active voice or data connection.

To telephone, fax, or modem PHONE 1 or 2

You can also pick up the handset and

listen for a dial tone.

On. PHONE 1 or 2 is on only when the

telephone, fax, or modem is in use.

Model Cisco 813

ETHERNET 10 BASE T

PHONE

CONSOLE

ISDN S/T

ISDN U

+5, -24, -71 VDC

Desktop power supply

Cisco 813 router

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Cisco 811 Installationsanleitung Seite 8