Cisco ADSL Modem Router Bedienungsanleitung PDF herunterladen

This article describes how to manually configure a Linksys Router for broadband DSL

that uses PPPoE (Point-to-Point Protocol over Ethernet) for authentication. For

automatic configuration options, please try:

1. Linksys Easy Connect (see Answer ID 1650 for more information), or

2. The Linksys Setup Wizard CD-ROM software that came with your Linksys

Router. Simply insert this CD-ROM into an online computer before connecting

your Linksys Router, and the Wizard will provide step-by-step instructions on

how to install and configure your router.

If you are unable to set up your Linksys Router by using one of the above

options, use the steps below to manually configure your router.

NOTE: It is recommended that you print this article for offline reference.

STEP 1: Before You Begin

In order to set up your Linksys Router, be sure to first have the following:

1. A Linksys Router.

2. A DSL modem.

3. A working computer that can be wired in directly to the router for initial

configuration and testing.

4. Two (2) standard Ethernet network cables. Linksys Routers come with one (1)

standard network cable that you can use.

5. The PPPoE DSL username and password assigned by your Internet Service

Provider. Depending on the provider, your username format might be similar to

username, vzn123456, or an e-mail address ([email protected]). If you are not

sure what your username and password are, contact your Internet Service Provider

for more information.

STEP 2: Check Your Internet Connection

Before installing your Linksys Router, it is important to first verify that you can

successfully access the Internet by connecting directly to your modem (without your

Linksys Router installed).

1. If you are connecting for the first time, follow the instructions provided by your

provider to set up your modem and computer for online access.

2. Verify that you are able to access the Internet without any problems. If you are

not able to get a connection, contact your Internet Service Provider for assistance.

When you are able to access the Internet using your modem, continue to Step 3 and

proceed with the installation of your Linksys Router.

1 2 3 4 5 6 7

Inhaltsverzeichnis

Seite 1

This article describes how to manually configure a Linksys Router for broadband DSL that uses PPPoE (Point-to-Point Protocol over Ethernet) for authen

Seite 2

STEP 3: Connect the HardwareFollow these steps to connect your Linksys Router to your modem and computer.1. Shut down your computer and unplug the pow

Seite 3

3. A user name and password prompt will appear. Leave the user name field blank (empty), and type in admin (lowercase) for the password. The password

Seite 4

5. Once PPPoE is selected, enter your PPPoE DSL username and password provided by your Internet Service Provider into the router’s User Name and Passw

Seite 5

4. Wait for about 30 seconds.5. Plug in the modem’s power cord. If there is an additional power switch required to power on your modem, be sure to use

Seite 6 -  PPPoE Authentication Failed

One of the following statuses may appear: ConnectingIf the status repeats with Connecting, your Linksys Router is having problems connecting to your

Seite 7

‘Power Cycle’ steps in Step 5 and try again. Be sure to check for solid status and activity lights on the modem and the Internet (or WAN) lights on th