Cisco Catalyst 2900 Series XL Installationsanleitung PDF herunterladen (Seite 14)

Chapter 1 Product Overview

Front-Panel Description

1-14

Catalyst 2900 Series XL Hardware Installation Guide

78-6461-04

Port LEDs and Modes

Each of the 10/100, 100BASE-FX, and LRE ports and module slots have a port

LED. These port LEDs, as a group or individually, display information about the

switch and about the individual ports. The port modes (Table 1-4 and Table 1-5)

determine the type of information displayed.

To select or change a mode, press the Mode button until the desired mode is

highlighted. When you change port modes, the meaning of the port LED colors

also changes. Table 1-6 and Table 1-7 list the port LED colors.

Solid amber The RPS is in standby mode or in a fault condition. Press the Standby/Activebutton

on the RPS, and the LED should turn green. If it does not, the RPS fan could have

failed. Contact Cisco Systems.

Blinking amber The internal power supply in a switch has failed, and the RPS is providing power

to the switch (redundancy has been allocated to this device).

Table 1-3 RPS LED on the Catalyst 2912 LRE XL and 2924 LRE XL Switches (continued)

Color RPS Status

Table 1-4 Port Mode LEDs on the Catalyst 2912 XL, 2924C XL, 2924 XL, 2924MF XL, 2924M XL, and

2924M XL DC Switches

Mode LED Port Mode Description

STAT Port status The port status. This is the default mode.

UTL Switch utilization The current bandwidth in use by the switch. (See Figure 1-8.)

FDUP Port duplex mode The port duplex mode: full duplex or half duplex, and default

modes:

• 10/100 ports: auto

• 100BaseFX ports: auto

• Gigabit ports: auto

100 Port speed The port operating speed: 10 or 100 Mbps.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Keine Kommentare

Cisco Catalyst 2900 Series XL Installationsanleitung Seite 14