Cisco 2975 Bedienungsanleitung PDF herunterladen (Seite 34)

2-16

Catalyst 2975 Switch Hardware Installation Guide

OL-17784-01

Chapter 2 Switch Installation

Connecting to the Stack Ports

Table- or Shelf-Mounting

To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit

envelope. Attach the four rubber feet to the recessed areas on the bottom of the chassis. Place the switch

on the table or shelf near an AC power source.

When you complete the switch installation, see the “After Switch Installation” section on page 2-16 for

more information on switch configuration.

After Switch Installation

• Configure the switch by running Express Setup to enter the initial switch configuration. See the

switch getting started guide in the

“Related Publications” section.

• Use the CLI setup program to enter the initial switch configuration. See Appendix C, “Configuring

the Switch with the CLI-Based Setup Program.”

• Connect to the stack ports. See the “Connecting to the Stack Ports” section on page 2-16.

• Connect to the front-panel ports. See the “Installing SFP Modules” section on page 2-17 and the

“10/100/1000 PoE Port Connections” section on page 2-19.

Connecting to the Stack Ports

Before connecting the stack cables, review the “Planning a Switch Stack” section on page 2-6. Always

use a Cisco-approved stack cable to connect the switches.

Step 1 Remove the dust covers from the stack cables and stack ports, and store them for future use.

Step 2 Use the window in the stack cable to align the connector. Insert the cable into the stack port on the switch

rear panel (

Figure 2-16). Tighten the retainer screws.

Step 3 Insert the other end of the cable into the connector of the other switch. Tighten the retainer screws.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 61 62

Keine Kommentare

Cisco 2975 Bedienungsanleitung Seite 34